API SQ and ILSAC GF-7: A New Era for Gasoline Engine Oil
API SP and ILSAC GF-6, the gasoline passenger car engine oil standards in place since 2020, have been succeeded. According to API's official licensing document API 1509, oils meeting API SQ and ILSAC GF-7 can be licensed starting March 31, 2025.
What Is API SQ?
Per the API 1509 definition, API SQ is the gasoline engine category adopted for oils available in 2025. It is designed for gasoline engines in current and earlier passenger cars, SUVs, vans and light-duty trucks.
The most important practical point: API SQ oils may be used where API SP and earlier S categories have been recommended. So if your manual says SP or SN, an SQ oil of the same viscosity can be used with confidence.
GF-7A vs GF-7B
The ILSAC standard is developed by Ford, General Motors, Stellantis and the Japan Automobile Manufacturers Association (JAMA). GF-7 has two sub-standards:
- ILSAC GF-7A: Covers 0W-20, 5W-20, 0W-30, 5W-30 and 10W-30. Shown on the pack with the API "Starburst" mark.
- ILSAC GF-7B: Covers SAE 0W-16 oils only. Shown on the pack with the API "Shield" mark.
What Got Tighter?
Key requirements from the GF-7A table in API 1509:
- Low-speed pre-ignition (LSPI) protection: The Sequence IX test for LSPI in turbocharged direct injection engines is now run on aged oil as well as fresh oil. The oil must keep protecting later in its service life.
- Chain wear: Timing chain elongation in the Sequence X test is limited to 0.080% maximum.
- Particulate filter compatibility: Sulfated ash max 0.9%. According to Infineum, this new limit was introduced to support aftertreatment such as gasoline particulate filters (GPF).
- Catalyst protection: Phosphorus max 0.08%, phosphorus retention min 81% in the Sequence IIIHB test.
- Fuel economy: The Sequence VIE test requires at least 4.3% total fuel economy improvement for XW-20 oils.
- Cold operation: New oil MRV pumpability limit of 40,000 cP maximum.
What Happened to GF-6?
According to Infineum, from March 31, 2026, oils meeting only GF-6A are no longer eligible to display the API "Starburst". The same date applies to GF-6B. Older stock may still be on shelves, but newly licensed products will be GF-7.
What to Check on the Label
- Owner's manual first: API 1509 states it clearly: follow the vehicle manufacturer's recommendation on viscosity and performance standard.
- Match the viscosity: If the manual says 0W-20, use 0W-20. The SQ label does not replace viscosity selection.
- Check the donut symbol: If the upper half reads "API SERVICE SQ", the oil meets the latest gasoline category.
- ACEA and OEM approvals for European cars: European vehicles usually require an ACEA class (such as C2, C3, C5) and an OEM approval (such as VW 508.00, MB 229.71). API SQ does not replace these, check both.
Browse the GMX Power product catalog or contact our team to choose the right engine oil for your vehicle.
Sources
- API 1509 Engine Oil Licensing and Certification System, 24th Edition (July 2026, amended September 23, 2026): api.org
- API Engine Oil Categories: api.org
- Infineum, ILSAC GF-7 licensing begins (April 2025): infineuminsight.com
- Infineum, ILSAC GF-7 changes (November 2024): infineuminsight.com

